The DB9 D-subminiature interface is typically used for RS-232 serial communications between PC's and peripheral devices. All of our 9-pin d-sub cables come fully populated with 24K Gold plated contacts, molded DB9 connectors, and offer varying degrees of shielding depending upon your specific requirements. CAT-PC cable) 25 pin female this may be standard, need to check - Ascension DB-9 connector (from RJ45 colors) 9 pin male 2 - green (TD) 3 - yellow (RD) 5 - red (SG) - 4 - grey (RTS) these two optional - needed for reset 9 - black (DTR) - Lightwave DB-9 connectors (from RJ45 colors) 9 pin male/female The dumbest possible connections - make no sense whatsoever.
Very simple. Maximum length of cable is about 5 m for AWG20 and 0.8 m for AWG28 cable.
Pin one side | Signal | Description | Pin other side |
1 | USB Vcc (Vbus) | usually RED, wire should be 20-28 AWG | 1 |
2 | USB Data - | usually WHITE, wire should be 28 AWG | 2 |
3 | USB Data + | usually GREEN, wire should be 28 AWG | 3 |
4 | GND | usually BLACK, wire should be 20-28 AWG | 4 |
USB D+ and D- are twisted in cable. Outer shell is made of copper braid and aluminum shield.
Colors do not mean anything in the wiring scheme. You can use any color wire to rig something. Just make sure the colors match from end to end. Using the de-facto color is for industry types only.
The maximum length of a standard USB cable (for USB 2.0 or earlier) is 5 metres with devices operating at full speed (12 Mbit/s) or high speed (480mbit/s), and a maximum length of 3 metres with devices operating at low speed (1.5 Mbit/s) The primary reason for this limit is the maximum allowed round-trip delay of about 1,500 ns. If USB host commands are unanswered by the USB device within the allowed time, the host considers the command lost. The USB 3.0 standard does not directly specify a maximum cable length, requiring only that all cables meet an electrical specification: for copper cabling with AWG 26 wires the maximum practical length is 3 meters.
The data cables for USB 1.x and USB 2.x use a twisted pair to reduce noise and crosstalk. USB 3.0 cables are more complex and employ shielding for some of the added data lines (2 pairs); a shield is added around the pair sketched.